MENU CONFIGURATION
(Defaults in Bold and Italics)

MENU	/DEV	/MAX
INPT INPUT TYPE	Show input choices:	Input Type J.TC Iron vs. Constantan (NIST) K.TC Chromel vs. Alumel (NIST) DJ.TC Iron vs. Copper (DIN) T.TC Copper vs. Copper-Nickel
DEC.P Decimal Point	Show decimal point position	FFFF. FFF.F
RD.CF Reading Configuration	R.1	C: Celsius F: Fahrenheit
S1.CF SETPOINT 1 CONFIGURATION	S.1 S.2	A: Active above B: Active below U: Unlatched L: Latched
S2.CF SETPOINT 2 CONFIGURATION	S.1 S.2	A: Active above B: Active below U: Unlatched L: Latched
S1.DB SETPOINT 1 DEADBAND	Scroll right one digit	Change flashing digit's value
S2.DB SETPOINT 2 DEADBAND	Scroll right one digit	Change flashing digit's value
Output Configuration Analog Output	0.1 0.2 0.3 0.4 0.5	D: Disabled E: Enabled V: Voltage analog out C: Current analog out A: Retransmission of temperature P: Proportional to error D: Proportional analog output is direct reading R: Proportional analog output is reverse acting F: 0-10 V proportional H: 0-5 V proportional
Notes * If you select 0.2=V, you may select your analog output to be 0-10 V or 0-5V by accessing sub-menu 0.5=F or 0.5=H * If 0.3=P, you may select your proportional output analog to be direct 0.4=D (4-20 mA), (0-5V), (0-10v) or reverse acting 0.4=R (20-4 mA), (5V-0V), (10V-0V).
P.BND Proportional Band	Show prior value entered	Change flashing digit's value
M.RST Manual Reset	Show prior value entered	Change flashing digit's value
OT.S.O Output Scale/Offset Enter new value & show "OUT1" Enter new value & show "RD 2" Enter new value & show "OUT2"	Show "RD 1" & prior value Scroll right one digit Show prior value Scroll right one digit Show prior value Scroll right one digit Show prior value	Change flashing digit's value Change flashing digit's value Change flashing digit's value Change flashing digit's value
C.J.OF Cold Junction Offset	Show actual or prior value	Change flashing digit's value (░C only)
LK.CF Lock Out Configuration	RS= SP= L3=	E (Enable RESET button in run mode) D (Disable RESET button in run mode) E (Enable setpoint changes) D (Disable setpoint changes) 0 (SETPTS button display setpoint values) 1 (SETPTS button display software "v.-03" version)